ZIPWAKE Dynamic Trim Control System, 600-S series kit


Warranty: 2 Years


The world’s first low-cost dynamic trim control system contains state-of-the-art, durable and fast-acting interceptors.
The system is fully automatic. It significantly improves performance and fuel consumption. The increased comfort and safety on board is clearly noticeable when accelerating, turning and sailing at sea or in waves.

    • Dynamically eliminates uncomfortable and dangerous boat pitch and roll.
    • Automatically minimizes wave resistance and saves fuel.
    • Provides built-in quality, simple installation and easy expansion, thus making the system affordable.
    • Easy to integrate into your existing navigation system via the NMEA 2000 network protocol.
    • The installation and configuration is explained step by step and can be installed by anyone.
    • Highly effective. Zipwake’s blade strok takes 1.5 seconds, outperforming conventional trim tabs by a factor of 5.
Zipwake’s interceptor blades extend only 30 mm, trim tabs ca. 150 mm. As a result, the so-called drag is much less than with the commonly used trim tabs.


For motor boats from 20 to 60 feet, maximum 60 knots.
For motor vessels larger than 60 feet, the Series-E was developed


The Zipwake Dynamic Trim Control System comes complete with everything you need, including all the necessary components and software for active motion control.
The system is expandable with various components, up to 3 pairs of straight interceptors or 2 pairs of straight and V-shaped interceptors, a GPS antenna, an extra flybridge panel, and your own navigation system through a NMEA200 connection and / or NMEA0183 / RS232 autobaud-rate sensing. Also the display has two USB ports (inbound/outbound).


Product ID: 58976


This kit includes:
1 x CP-S Control panel with 7m cable
1 x DU-S Distribution unit with 3m power cable.
1 x IT300-S Chine Port Interceptor with 3m cable + covers
1 x IT300-S Chine Starboard Interceptor with 3m cable + covers
1 x EC-M12 extension cable 1.5m
1 x Operating instructions
1 x Warranty card
1 x Installation manual
1 x Drilling template
Zipwake – Kit Box
A Zipwake Kit Box includes all parts needed to install a Dynamic Trim Control System with one pair of fast-acting interceptors.
There are four different Kit Boxes with straight interceptors available, and two different Kit Boxes with chine and V-shape interceptors.
A Kit Box consists of the control panel, the distribution unit, the interceptor and an extension cable.

The Kit Box number specifies the length of the interceptor:

  • Kit Box 300-S: 2 x 300 mm (straight) Kit Box Part No. 2011145
  • Kit Box 450-S: 2 x 450 mm (straight) Kit Box Part No. 2011146
  • Kit Box 600-S: 2 x 600 mm (straight) Kit Box Part No. 2011147
  • Kit Box 750-S: 2 x 750 mm (straight) Kit Box Part No. 2011148

Kit Box 300-S: 2 x 300 mm (Chine)

  • IT300-S CHINE PORT Kit Box Part No. 2011702
  • IT300-S CHINE STBD Kit Box Part No. 2011703

Kit Box 450-S: 2 x 450 mm (Chine)

  • IT450-S CHINE PORT Kit Box Part No. 2011704
  • IT450-S CHINE STBD Kit Box Part No. 2011705


There are no reviews yet.

Show only reviews in English (0)

Be the first to review “ZIPWAKE Dynamic Trim Control System, 600-S series kit”
Project! AB Marine service

Your email address will not be published. Required fields are marked *