Engine Control

Showing 25–38 of 38 results

Morse cables

With this name, you might imagine the outdated lines for a telegraph, but nothing could be further from the truth. Our morse cables are the flexible push and pull cables you can use for engine control of inboard and outboard engines. These take care of the changeover when you accelerate or put your ship in forward or reverse. At AB Marine Service, you have a choice of sizes. Which morse cables you should have again depends on the distance between the throttle and the motor. On the cable, the length is probably indicated in ft. For sufficient slack, always count 120 cm of extra cable length, which is four feet. Always avoid laying the cables in bends so that they cannot pinch off.

Is the above story still not entirely clear? For questions, please feel free to contact us.

Engine control

Once you have properly installed your boat’s engine controls, you will have virtually nothing to worry about. At least, not to the control system: the moving parts of the shift arm do need to be greased periodically, as does the one-hand handle of the steering position. However, make sure you don’t run your engine control cables on a sharp bend, otherwise they will wear out quickly and you will need replacement every so often. Does a cable from your boat’s engine controls break anyway? This is annoying, but not a disaster, as you can simply operate the engine or clutch by hand.

By the way, did you know that we have an extensive and useful technical blog? There you will find many practical tips and instructions regarding maintenance and adjustments to your boat!

Showing 25–38 of 38 results